The phenomenon of high temperature production environment of high pressure hose

Friends who sell high pressure hose may meet and often meet the quality problems of high pressure hose manufacturers in the summer. In fact, this is a common thing. In particular, the manufacturer is particularly sensitive to the high pressure hose made at this time.
Why is it like this?
Listen to me.
In the process of high pressure rubber hose, it is important to have a link, which is water temperature.
Water temperature is too high, mixing in the mixing process, if the control is not good, it is easy to glue. In summer, in winter, the temperature is relatively high. When the basic rubber is mixed, the control of water temperature is not good. It will vaporized the oil of mixing power. Rubber mixes (mother gum) dry, if it is in the gum base glue, then to feed (eat sulfur). It's likely to have a quality problem.
On the other hand, if the glue glue in the mother in the feeding, water temperature (eat sulfur) not controlled, the water temperature is too high, will cause local glue. Appearance of glue particles. These particles are the hidden dangers of the leakage of high pressure hose.
Again, the old problem, or the temperature problem, if the finished product glue time is too long, no place in the cool place. It is easy to self sulfur. Never be more than a month. In one month, the average daily temperature is over 35 degrees, which can cause the self sulfur reaction very much. Then, then again, the glue can't be used. Sometimes, the middleman find this time this high pressure hose come out, this skin is especially good peeling, that congratulations you. You happen to meet self sulphur treatment and mix with good glue. The adhesiveness of the adhesive is not good. However, this is not possible since all Thioplast, because all, cannot come out extruder, are cured rubber particle. It can't be squeezed out at all.